✅ for welding
✅ Toe and camber adjustable
✅ Quick and easy adjustment option
✅ Significantly more direct feedback to the driver
✅ Suspension can react faster and more accurately
✅ Enables exact adjustment of the chassis
✅ with high-quality spherical bearings
Do your own DTM
The components are welded to the OEM trailing arm and replace the original, rigid mounts for the rear axle carrier. Due to their construction, they allow the camber and toe values of the rear wheels to be adjusted when installed. This construction was used in exactly the same way in the BMW E30 DTM Group A/Group N vehicles.
QUICK ADJUSTMENT
With the one-hand camber adjustment, you can easily change your values in no time without much effort and are therefore very flexible.
NOTHING BUT THE BEST.
In addition to the adjustment set, you can order the required uniball bearings from us at the same time. These are also homemade by MRT Engineering and an absolute guarantee for the best quality and longevity!
WHY UNIBALL
Factory landing gear bushings tend to be soft for comfort and provide a degree of play at the linkage. However, the forces occurring at the wheel are then transmitted to the chassis in a distorted manner and vice versa. As a result, the chassis is sluggish and cannot react to these forces to the full extent of its capabilities. This also applies to the driver. This play can be eliminated with rigid bushings and the chassis can be fully exploited.
If values such as camber, track, caster, etc. are set, the vehicle is at a standstill. If it is now set in motion, there will be slight deviations from these values due to the intended play in the factory rubber bushings. While these deviations are negligible in road traffic, they can make the difference between victory and defeat at the limit. Rigid bushings eliminate this play and ensure you always ride at the exact values you set
MEASUREMENTS
When using this adjustment set, the side members must also be reinforced!
NOTE:
The adjustment set for the Horizontal mounting can be used with the original rear axle carrier and trailing arm.
The adjustment set for the Vertical mounting can only be used with modified rear axle carrier. The original trailing arms cannot be used either!
Delivery:
- Adjustment set left & right
- 2x uniball bearings
- 2x spherical bearings
TECHNICAL SPECIFICATIONS
Manufacturers |
MRT engineering |
Suitable for |
BMW E30 | E36 Compact | Z3 - also for M3 version
|
Verstellbereich |
Camber: 40mm | Track: 30mm |
Material |
CrMo steel |