WISEFAB DRIFT steering angle kit Mazda RX-7 FD front axle

✅ Steering angle up to 62° and adjustable Ackermann angle
✅ More usable steering angle thanks to improved geometry
✅ Higher roll center and bump steer correction
✅ minimal camber changes when compressing
✅ optimized restoring forces

PROVEN WITH THE PROFESSIONALS

WISEFAB steering angle kits can be found on almost every Formula Drift team. The best proof of the superior benefits and performance these kits bring.

MORE OF EVERYTHING

The specially designed wishbones give the bike significantly more room to turn. Together with the optimized tie rods, this results in a steering angle of up to 62°. If that's too much for you, you can set it smaller. With the included Ackermann adjustment kit, you can adjust the Ackermann angle to your needs in just a few simple steps, without affecting other settings.

IMPROVED KINEMATICS AND GEOMETRY

Due to the optimized chassis geometry, the camber of the front wheels remains stable over the entire steering range and thus always offers you perfect grip on the front wheels.

An increased roll center improves the feedback you get from your steering and reduces body roll in corners and during rapid changes of direction. This optimization of the roll center even allows the front anti-roll bar to be removed.

Since the spread can become a problem with such large steering angles, this point was also optimized without minimizing the restoring forces. Instead, the restoring forces are almost constant and easy to control over the entire steering range thanks to sophisticated kinematics.

Furthermore, the geometry was designed in such a way that, despite the high steering angle, the steering cannot jam when the steering is fully turned.

DETAILS

The original stabilizer bar can be used.

The kit is designed for a vehicle height of 80 mm (front axle support to the ground).

A maximum wheel circumference of 635 mm is recommended (215/45R17, 225/45R17, 235/40R17, 225/40R18 etc ). If the scope is larger, the wheel housing liners must be adjusted.

Minimum wheel size is 17".

Recommended backspace is ~135 mm (7" ET45; 8" ET35; 9" ET20). If the ET is larger, track plates must be used.

This kit requires the use of a coilover kit and is a motorsport product and not approved for public road traffic.

Delivery:Upper/lower wishbones, tie rods, tie rod ends, steering knuckles, fastening material, installation instructions

TECHNICAL SPECIFICATIONS