WISEFAB TRACK steering knuckle kit suitable for Subaru Impreza rear axle

✅ maximum grip
✅ 50mm roll center correction
✅ 1 kg weight saving, mainly unsprung mass
✅ Brake caliper is mounted on the steering knuckle
✅ OEM handbrake can continue to be used
✅ Trailing arm connection with Uniball bearing

EVERYTHING UNDER CONTROL

The Subaru Impreza is one of the absolute legends in rallying. So it's no wonder that it's also used very successfully on the track. Of course, the Scooby has to be lowered for this use, but this affects the factory chassis geometry in such a way that it no longer works as intended. This primarily affects the roll center, anti-squat, bump steer and camber of the front wheels. These sizes are corrected by the Wisefab Kit.

In addition, the WISEFAB kit weighs 1 kg less than the corresponding OEM parts. This mainly affects unsprung mass.

IMPROVED KINEMATICS AND GEOMETRY

Thanks to the optimized chassis geometry, the camber of the rear wheels remains in a perfect range over the entire suspension travel and thus always offers you enough grip.

The roll center, corrected by 50 mm, reduces body roll in curves and during rapid changes of direction.

The bump steer, i.e. the toe-in change during compression, has been adjusted to a reduced vehicle height. The same goes for the anti-squat properties.

DETAILS

Compatible wheel bearings:
- 2000 - 2007 WRX/STI 72x42x52 wheel bearings

Compatible hubs:
- 5x100 hub (OEM no: 28462FE001)
- 5x114,3 hub (OEM no: 28462FE011)

The original wheel speed sensors can still be used.

For greater strength, the brake caliper is mounted directly on the steering knuckle. To do this, the OEM brake caliper mount must be cut off the dust cover.

All components are supplied preset and can be installed directly.

This kit requires the use of a coilover kit. The kit is a motorsport product and is not approved for use on public roads.

Delivery: Steering knuckle left & right, fastening material, installation instructions

TECHNICAL DATA