Complete kit consisting of four parts: x2 front fender flares, x2 rear fender flares.
The same kit is also suitable for a coupe. To accommodate the convertible's lower waistline in the trunk area, it is recommended to cut approximately 20mm from the top edge of the rear panels.
MATERIAL – Reinforced GRP with additional layer of multi-axial fiberglass fabric. This improved the structural rigidity of the fenders. This makes them very robust and they can withstand contact with the edge of the rim, stones, burst tires, etc. without any problems.
The rear arch line is reformed and raised by approximately 20mm, allowing you to eliminate the tilt effect and properly align your E36. No more exposed rear axle or exhaust.
+35 mm width at the front per side, +52 mm width at the back per side
*It is recommended that installation be carried out by a body shop. Adjustments may be required to ensure a proper fit, including cutting, trimming, padding, sanding and adjusting. *Before painting, it is recommended to preheat fender flares to release trapped air beneath a gel coat.
All Fitment Lab parts have a TÜV test report.