WISEFAB DRIFT steering angle kit Nissan Skyline R32 front axle

✅ Adjusted steering ratio for a better steering feel and more control
✅ Steering angle up to 65° and adjustable Ackermann angle
✅ More usable steering angle thanks to improved geometry
✅ Higher roll center and bump steer correction
✅ minimal camber changes when compressing
✅ optimized restoring forces

PROVEN WITH THE PROFESSIONALS

WISEFAB steering angle kits can be found on almost every Formula Drift team. The best proof of the superior benefits and performance these kits bring.

MORE OF EVERYTHING

The newly designed wishbones give the bike significantly more room to turn. Together with the optimized steering knuckles and tie rods, this results in a steering angle of up to 65°. If that's too much for you, you can set it smaller.

With the included Ackermann adjustment kit, the Ackermann angle can be adjusted to personal needs in just a few simple steps, even on the side of the road. The offset rack spacers prevent the steering from locking when the steering is fully turned.

IMPROVED KINEMATICS AND GEOMETRY

Due to the optimized chassis geometry, the camber of the front wheels remains stable over the entire steering range and thus always offers you perfect grip on the front wheels.

The independent steering of the wheels during compression (bump steer) is also almost completely eliminated. An increased roll center improves the feedback you get from your steering and reduces vehicle body roll when making quick changes in direction.

Since the spread can become a problem with large steering angles, this point was also optimized. The up and down movement of the front end when steering is almost completely eliminated without minimizing the restoring forces. Instead, the restoring forces are almost constant and easy to control over the entire steering range thanks to sophisticated kinematics.

DETAILS

S14 wheel hubs are required for use.

Not compatible with GTR or other 4WD models.

The chassis geometry was designed for a vehicle height (front axle carrier to ground) of ~80 mm.

With a total wheel diameter of 635 mm or more (225/45R17, 235/40R17, 235/35R18, 255/30R18 etc.) the wheel arch liners have to be slightly modified. Minimum wheel size is 17".

The recommended backspace is 135 mm (7" ET45; 8" ET35; 9" ET20). If the ET is larger, track plates must be used.

This kit requires the use of a coilover kit and is a motorsport product and not approved for public road traffic.

Delivery: Steering knuckles, lower wishbones, tie rods, tie rod ends, offset rack spacers, Ackermann adjustment kit, installation instructions, fastening material

TECHNICAL DATA